Bucket Seats

Safety Belt Bolt Bit:

SPECIAL SERVICE TOOLS

REMOVAL

WARNING: ALL SAFETY BELT ASSEMBLIES INCLUDING RETRACTORS, BUCKLES, FRONT SEAT BELT BUCKLE SUPPORT ASSEMBLIES (SLIDE BAR), SHOULDER BELT HEIGHT ADJUSTERS (IF SO EQUIPPED) CHILD SAFETY SEAT TETHER ATTACHMENTS AND ATTACHING HARDWARE SHOULD BE INSPECTED AFTER ANY COLLISION. ALL BELT ASSEMBLIES SHOULD BE REPLACED UNLESS A QUALIFIED TECHNICIAN FINDS THE ASSEMBLIES SHOW NO DAMAGE AND OPERATE PROPERLY. BELT ASSEMBLIES NOT IN USE DURING A COLLISION SHOULD ALSO BE INSPECTED AND REPLACED IF EITHER DAMAGE OR IMPROPER OPERATION IS NOTED.

1. Remove the floor console.







2. Move the seat forward and use Safety Belt Bolt Bit to remove the slide bar bolt.
3. Remove the front seat.







4. Remove the safety belt slide bar.
1 Disconnect the electrical connector (LH only).
2 Remove the nut.
3 Remove the bolt.
4 Remove the slide bar.







5. Remove the safety belt buckle.
1 Clamp the slide bar in a suitable vise.
2 Use Safety Belt Bolt Bit to remove the bolt.
3 Remove the buckle.

NOTE: Clamp the slide bar collar in a vise along the break line only.

INSTALLATION
















1. To install, reverse the removal procedure.