Blower Motor: Service and Repair

REMOVAL
1. Disconnect the battery ground cable. For additional information, refer to Battery.







2. Remove the speed control servo.
1 Disconnect the electrical connector.
2 Remove the bolt.
3 Position the speed control servo aside.







3. Position the coolant/washer reservoir.
1 Remove the screws and the nuts.
2 Move the coolant/washer reservoir aside.







4. Remove the blower motor.
1 Disconnect the vent hose.
2 Disconnect the electrical connector.
3 Remove the four screws.
4 Remove the blower motor.

INSTALLATION












1. To install, reverse the removal procedure.