Muffler: Service and Repair

Removal





1. Remove the two bolts and loosen the clamp.





2. Disconnect the RH torsion bar link.
- Remove the nut and position the torsion bar link out of the way.





3. Pry the rear support slide out of the rubber insulator.





4. Pry the double support slides away from the insulators.
5. Remove the muffler. Slide the muffler forward over the rear axle while twisting the muffler until the muffler is removed.

Installation

1. Install the muffler over the rear axle and twist the muffler into position.





2. Note: Before installing the muffler into the rubber insulators, apply a soap solution to the support slides.

Push the double support slides into the rubber insulators.





3. Push the rear support slide into the rubber insulator.





4. Position the RH torsion bar and install the nut.





5. Install the bolts.





6. Tighten the clamp.