Cruise Control Servo Cable: Service and Repair

REMOVAL







1. Remove the accelerator control splash shield. Remove the bolts.







2. Remove the speed control actuator cable .
1 Remove the bolt.
2 Remove the speed control actuator cable from the throttle linkage.








3. Remove the speed control actuator cable cap from the speed control servo.
^ Push in the locking arm on the speed control actuator cable cap then rotate the cap counterclockwise.







4. Disconnect the speed control core wire end from the speed control servo pulley.
1 Depress the spring retainer.
2 Slide the core wire end out of the speed control servo pulley.

INSTALLATION







1. Insert the speed control cable slug into the speed control servo pulley slot.
1 Gently compress the speed control servo spring.
2 Insert the speed control cable slug into the speed control servo pulley slot.







2. Release the compressed spring while aligning the speed control actuator cable cap tabs with the slots in the speed control servo housing.

WARNING: INCORRECT WRAPPING OF THE SPEED CONTROL ACTUATOR CABLE AROUND THE SPEED CONTROL SERVO PULLEY MAY RESULT IN A HIGH IDLE CONDITION.

NOTE: Make sure the rubber seal is fully seated onto the speed control actuator cable cap.







3. Rotate the speed control actuator cable cap until the locking arm engages.







4. Snap the speed control actuator cable and the accelerator cable together in the clip and install the cables onto the accelerator cable bracket.

CAUTION: The guide pin must be fully seated before installing the speed control actuator cable bolt.







5. Position the accelerator control splash shield and install the bolts.