Hood Latch Release Cable: Service and Repair

REMOVAL

NOTE: The hood latch control handle and cable are replaced as an assembly.

1. Remove the hood latch. For additional information, refer to Hood Latch.







2. Unclip the hood latch control handle and cable retainer from the inner fender splash shield.







3. Position the hood latch control handle and cable aside.
1 Remove the two screws.
2 Position the hood latch control handle and cable aside.







4. Remove the hood latch control handle and cable.
1 Remove the hood latch control and cable grommet from the dash panel.
2 Remove the hood latch control handle and cable.

INSTALLATION







1. To install, reverse the removal procedure.