Stator to Impeller Interference Check

1. Position the stator support with the splines up.

NOTE: The stator support can remain in the pump assembly during this test.





2. Mount the (A) torque converter on the (B) stator support so that the splines on the one-way clutch inner race engage the mating splines of the stator support.

NOTE: The assembled pump can be used for the following steps.





3. Hold the stator support stationary and rotate the torque converter counterclockwise.
- The torque converter should rotate freely, with no signs of scraping.
- If there are signs of scraping, replace the torque converter.