Front Shoulder Strap Adjuster With Stripped Weld Nuts

1. Remove the shoulder safety belt height adjuster.






2. Drill out the damaged threads in the upper B-pillar structure, using a 1/2-inch drill.






3. Apply a suitable lubricant to the threads of a M14-1.5 tap and tap new threads.

NOTE: After each rotation, back the tap off slightly to remove new cuttings and make sure to blow out any chips.






4. Select Thread Insert N807170-190 and hand-screw it into the tapped hole until it is slightly below the surface of the hole.






5. Using a l2-oz hammer, lightly tap the installation tool several times to drive down the insert "kees".

NOTE: Drive "kees" on the insert will act as an automatic stop.

6. Install the shoulder safety belt height adjuster.

NOTE: If the shoulder safety belt height adjuster retaining bolts are stripped, replace the shoulder safety belt height adjuster and retaining bolts. Refer to the Parts Replacement Chart in Specifications.