Throttle Body: Service and Repair

REMOVAL

CAUTION: The throttle body bore and plate area have a special coating and cannot be cleaned.





1. Remove the accelerator control splash shield.
1 Remove the three accelerator control splash shield bolts.
2 Remove the accelerator control splash shield.
2. Remove the air cleaner outlet tube from the throttle body.





3. Disconnect the Throttle Position (TP) sensor electrical connector.





4. Disconnect the (A) accelerator cable and the (B) speed control actuator cable.





5. Remove the throttle body.
1 Remove the four throttle body bolts.
2 Remove the (A) throttle body and the (B) throttle body gasket.
- Discard the throttle body gasket.

INSTALLATION









To install, reverse the removal procedure.