Harmonic Balancer - Crankshaft Pulley: Service and Repair
REMOVAL1. Remove the engine cooling fan and fan shroud.
2. Remove the drive belt.
3. Raise and support the vehicle.
4. Remove the crankshaft pulley bolt.
5. Using the Crankshaft Damper Remover, remove the crankshaft pulley.
6. Use the (A) Front Cover Seal Remover to remove the (B) crankshaft front seal.
INSTALLATION
1. Lubricate the (A) engine front cover seal bore and the (B) crankshaft front seal inner lip.
^ Use SAE 50W engine oil meeting Ford specification WSE-M2C908-A1.
2. Use the (A) Crankshaft Seal Replacer/Aligner to install the (B) crankshaft front seal into the (C)engine front cover.
3. Apply silicone to the Woodruff key slot on the crankshaft pulley.
^ Use Silicone Gasket and Sealant F6AZ-19562-A or equivalent meeting Ford specification WSE-M4G323-A6.
NOTE: If not secured within 4 minutes, sealant must be removed and the sealing area cleaned with solvent. Allow to dry until there is no sign of wetness, or 4 minutes, whichever is longer. Failure to follow this procedure can cause future oil leakage.
4. Use the Crankshaft Damper Replacer to install the crankshaft pulley.
5. Tighten the crankshaft pulley bolt in four stages.
Stage 1: 90 Nm (66 ft. lbs.)
Stage 2: Loosen 360 degrees
Stage 3: 47-53 Nm (35-39 ft. lbs.)
Stage 4: Rotate 85-90 degrees
6. Lower the vehicle.
7. Install the drive belt.
8. Install the engine cooling fan and the fan shroud.