Brake Pressure Switch

REMOVAL
1. Disconnect the battery ground cable. On vehicles equipped with dual batteries use proper disconnect procedures. Dual Battery Disconnect





2. Disconnect the brake pressure switch electrical connector, then remove the brake pressure switch.

INSTALLATION
1. Follow the removal procedure in reverse order.

NOTE
- On vehicles equipped with dual batteries use proper reconnect procedures. Dual Battery Disconnect
- When the battery is disconnected and reconnected, some abnormal drive symptoms may occur while the powertrain control module relearns its adaptive strategy. The vehicle may need to be driven 16 km (10 miles) or more to relearn the strategy.
- After the procedure is finished, perform brake bleeding procedures.