Front Passenger Side Stepwell Cover - Not Flush
Article No.99-18-11
09/06/99
BODY - FRONT PASSENGER SIDE STEPWELL
COVER NOT FLUSH - SERVICE TIP
FORD:
1997-1999 ECONOLINE
ISSUE
The rearmost portion of the front passenger side stepwell cover may not sit flush over the side passenger/cargo door stepwell cover at the B-pillar if the side passenger/cargo door stepwell cover is replaced with new service parts that were built after 8/1/1999. This may be due to a tooling change in the side passenger/cargo door stepwell cover.
ACTION
Check the rear of the front passenger side stepwell cover for a plastic positioning tab at the rear (Figure 1). If plastic positioning tab is present, eliminate the interference between the stepwells at the right B-pillar by removing the round plastic positioning tab from the rear of the front passenger side stepwell cover (Figure 2).
OTHER APPLICABLE ARTICLES: NONE
WARRANTY STATUS: INFORMATION ONLY
OASIS CODES: 107000