Rear Seat Radio Control

REMOVAL
1. Disconnect the battery negative cable.

NOTE: It is not necessary to completely remove the quarter trim finish panel to remove the rear seat radio control.

2. Remove the quarter trim finish panel.






3. Disconnect the electrical hardshell connector from the back of the rear seat radio control.






4. Remove the (A) rear seat radio control from the
(B) quarter trim finish panel.

INSTALLATION

NOTE: When the battery has been disconnected and reconnected, some abnormal drive symptoms may occur while the powertrain control module (PCM) relearns its adaptive strategy. The vehicle may need to be driven 16km (10 miles) or more to relearn the strategy.

1. Follow the removal procedure in reverse order.