Wiper Motor: Service and Repair

REMOVAL

Wiper Motor And Linkage Module:

1. Remove wiper arms and blades, disconnect hoses from in-line connectors. Be sure that the in-line connector is saved.
2. Remove the rear hood seal with the cowl top plastic screen and disconnect the washer hose at inline connector. Save in-line connector.
3. Disconnect motor connector at back side of housing.
4. Remove four wiper housing module mounting screws then remove housing.
5. Remove nut and disconnect wiper drive link from motor crank.
6. Remove three motor mounting screws.
7. Lift motor and mounting plate out of housing.
8. Disconnect motor harness grommet from housing.

INSTALLATION
- For installation, reverse the above procedures. Tighten the motor crank nut to 11 to 14 N.m (89 to 124 in. lbs.) torque. Tighten the motor mounting screws to 11 to 12 N.m (89 to 106 in. lbs.) torque.