LH/CP

REMOVAL
1. Release hood latch and open hood.
2. Remove radiator closure panel sight shield as necessary to gain access to headlamps.
3. Remove screws holding headlamp module halves together.
4. Separate module halves.
5. Remove fog lamp wire connector cover.

Foglamp Bulb:

6. Disengage wire connectors from fog lamp bulb.
7. Disengage retainer clip holding bulb to fog lamp.
8. Separate bulb from fog lamp.

INSTALLATION
1. Place bulb in position in fog lamp.
2. Engage retainer clip to hold bulb to fog lamp.
3. Engage wire connectors on fog lamp bulb.
4. Install fog lamp wire connector cover.
5. Place module halves together.
6. Install screws to hold headlamp module halves together.
7. Install radiator closure panel sight shield.
8. Verify fog lamp operation and alignment.