Installation

PROCEDURE
1. Raise vehicle.

Park Brake Cable Attachment To Park Brake Lever:

2. Install parking brake cable into rear brake support plate. Be sure the park brake retainers are expanded around mounting hole in brake support plate. Connect parking brake cable to park brake lever on trailing brake shoe.
3. Install parking brake cable into cable mounting hole in floor pan of vehicle. Be sure that cable retainers are expanded around mounting hole in floor pan.

Park Brake Cable Routing Clips:

4. Install the 4 routing clips attaching rear park brake cable to floor pan and frame of vehicle.

Park Brake Cable Removal From Floor Pan:

5. Connect the park brake cable to the park brake cable equalizer.

NOTE: The equalizer can be moved rearward to allow connection of the rear cable to the equalizer.

6. Lower vehicle.
7. Install upper center console cover assembly back in vehicle.
8. Install shift knob on floor shifter (if equipped). Shift knob is installed by pushing shift knob down shift shaft until fully bottomed. Then install and tighten 3/32 inch allen head set screw located on drivers side of shift knob.
9. Install hub/bearing assembly on spindle.

Hub And Bearing Retaining Nut:

10. Install the washer and retaining nut for the hub/bearing assembly. Tighten the retaining nut to a torque of 168 Nm (124 ft. lbs.).
11. Install wave washer, nut retainer and cotter pin on rear spindle.
12. Install hub/bearing dust cap.
13. Install the brake drum, and the wheel and tire assembly.
14. When repairs are complete, adjust rear brakes before adjusting parking brake. See Parking Brake System Adjustments for complete parking brake adjustment procedure.