Installation

PROCEDURE

Park Brake Cable Attachment To Park Brake Lever:

1. Install parking brake cable into rear disc brake adapter. Be sure the cable retaining tabs are expanded around mounting hole in brake adapter. Connect parking brake cable end to brake shoe assembly actuator lever.
2. Install parking brake cable into cable mounting hole in floor pan of vehicle. Be sure that cable retainers are expanded around mounting hole in floor pan.

Park Brake Cable Routing Clips:

3. Install the 4 routing clips attaching rear park brake cable to floor pan and frame of vehicle.
4. Lower vehicle.

Front Park Brake Cable Connection At Equalizer:

5. Connect the park brake cable to the park brake cable equalizer.

NOTE: The equalizer can be moved rearward to allow connection of the rear cable to the equalizer.

Park Brake Equalizer And Cover:

6. Install equalizer cover back on reaction bracket. Torque equalizer cover to reaction bracket mounting bolts to 10 Nm (88 in. lbs.).
7. Fold rear passenger compartment carpeting back into position.
8. Install both lower rear door opening sill moldings.
9. Install the rear seat lower cushion back in vehicle.
10. Install drivers side seat assembly back in vehicle.
11. Return the driver and passenger side seats back to their original positions.
12. Raise vehicle.
13. Install the parking brake shoes on the rear disc brake adapter. See Park Brake Shoes Service and Repair for the installation procedure.
14. Adjust the park brake shoes to an outside diameter of 171.5 mm (6.75 in.).
15. Install hub/bearing assembly on spindle.

Hub And Bearing Retaining Nut:

16. Install the washer and retaining nut for the hub/bearing assembly. Tighten the retaining nut to a torque of 168 Nm (124 ft. lbs.).
17. Install the wave washer, nut retainer and cotter pin on rear spindle.
18. Install hub/bearing dust cap.
19. Install rear rotor on the rear hub assembly. Install rear disc brake caliper assembly on adapter.
20. Install rear tire and wheel assembly on vehicle.