With Bucket Seats

PROCEDURES
1. Remove drivers seat assembly from vehicle.
2. Remove shift knob from floor shifter. Shift knob is removed by removing 3/32 inch allen head set screw located on drivers side of shift knob and pulling strait up on shift knob.
3. Remove center console cover from vehicle.

Sill Molding And Kick Molding:

4. Remove drivers side door opening sill molding. Remove drivers side cowl kick molding to expose park brake pedal mechanism.

Console Mounting Bracket And Heat Duct:

5. Remove rear console mounting bracket from park brake cable reaction bracket. Remove rear passenger compartment heat duct from vehicle for access to park brake cables.

NOTE: The throttle pedal and bracket have to be removed from the dash panel to allow carpet to be folded back.

6. Fold back carpeting to expose front park brake cable and routing clips.

WARNING: PARK BRAKE PEDAL ASSEMBLY SELF ADJUSTER MECHANISM MUST BE RELOADED AND LOCKED TO REMOVE TENSION FROM PARK BRAKE CABLES. THIS MUST BE DONE BEFORE REMOVE THE FRONT PARK BRAKE CABLE FROM THE PARK BRAKE CABLE EQUALIZER. FAILURE TO DO THIS WILL MAKE ASSEMBLY EXTREMELY DIFFICULT AND COULD LEAD TO SERIOUS INJURY.

7. Reload the self adjuster mechanism of the park brake pedal. Use the procedure as described in Parking Brake System Service and Repair.

Front Park Brake Cable Connection At Equalizer:

8. Remove front park brake cable from park brake cable equalizer.

Front Park Brake Cable Retaining Clip:

9. Remove the front park brake cable to reaction bracket retaining clip, by prying it off cable using a screwdriver.

Front Park Brake Cable Routing And Clipping:

10. Remove front park brake cable from reaction bracket. Remove screw, attaching park brake cable routing clip to left front floor pan. Remove front park brake cable from the 2 routing clips attached to the floor pan crossmember.

Park Brake Pedal Mechanism:

11. Remove the bolt attaching park brake pedal assembly to left front door frame. Loosen but do not remove the 2 bolts attaching park brake pedal assembly to cowl panel. Unplug the brake warning light connector from switch on park brake pedal assembly. Remove park brake pedal mechanism and front park brake cable as an assembly from the vehicle.

WARNING: PARK BRAKE PEDAL ASSEMBLY SELF ADJUSTER MECHANISM MUST BE RELOADED AND LOCKED TO REMOVE TENSION FROM PARK BRAKE CABLES. THIS MUST BE DONE BEFORE REMOVING THE FRONT PARK BRAKE CABLE FROM THE PARK BRAKE CABLE PEDAL ASSEMBLY. FAILURE TO DO THIS WILL MAKE ASSEMBLY EXTREMELY DIFFICULT AND COULD LEAD TO SERIOUS INJURY.

Park Brake Cable Retaining Clip:

12. Mount park brake pedal assembly in a vise. Remove front park brake cable to park brake assembly retaining clip.

Park Brake Cable Removal From Park Brake Mechanism:

13. Rotate park brake cable, aligning cable with notch in cable attaching hole. Then remove park brake cable from park brake pedal assembly.