With Bucket Seats

PROCEDURE
1. Install park brake cable assembly, through hole in park brake pedal assembly.

Park Brake Cable Removal From Park Brake Mechanism:

2. Install park brake cable in attaching hole on park brake assembly. Install park brake cable into cable attaching hole in park brake assembly, and rotate cable into place. Be sure cable is properly seated in the cam surface track of foot lever assembly.

Park Brake Cable Installed In Mechanism:

3. Install park brake cable to park brake pedal mechanism retaining clip. Be sure retaining clip is fully installed on park brake cable.

Park Brake Pedal Mechanism:

4. Install park brake pedal mechanism onto the 2 loosened mounting bolt on cowl panel. Install the park brake pedal assembly retaining bolt into door frame. Torque all 3 park brake assembly mounting bolts to 27 Nm (19 ft. lbs.).
5. Connect the brake warning light wire from vehicles wiring harness, onto switch located on park brake pedal mechanism.
6. Route front park brake cable along floor of vehicle. Install end of front park brake cable into mounting hole in reaction bracket. Install front park brake cable to reaction bracket retaining clip. Be sure retaining clip is fully installed on cable. Install front park brake cable into equalizer.

Front Park Brake Cable Routing And Clipping:

7. Install the park brake cable routing clip to floor pan attaching screw. Torque the routing clip to floor pan attaching screw to 4 Nm (35 in. lbs.). Install front park brake cable into routing clips on floor pan crossmember.

Correct Park Brake Cable Routing:

Locking Pin Installed In Park Brake Mechanism:

8. Ensure that park brake cable is properly routed in cam surface track of park brake pedal assembly. Using a pair of pliers, firmly grasp the allen wrench previously installed in park brake mechanism. Remove the allen wrench from the park brake pedal mechanism, using a firm and rapid pull. When allen wrench is removed from the park brake pedal mechanism, the park brake mechanism and park brake cables will automatically adjust. See Parking Brake System Adjustments for complete parking brake adjustment procedure.
9. Fold carpeting back into position on left floor pan of vehicle. Install throttle pedal and bracket back on dash panel studs and install attaching nuts.

Console Mounting Bracket And Heat Duct:

10. Install rear passenger compartment heat duct. Install rear console assembly mounting bracket on park brake cable reaction bracket. Torque rear console assembly mounting bracket to reaction bracket mounting bolts to 10 Nm (88 in. lbs.).

Sill Molding And Kick Molding:

11. Install drivers side cowl kick molding. Install drivers side door opening sill molding.
12. Install upper center console cover assembly back in vehicle.
13. Install shift knob on floor shifter (if equipped). Shift knob is installed by pushing shift knob down shift shaft until fully bottomed. Then install and tighten 3/32 inch allen head set screw located on drivers side of shift knob.
14. Install drivers side seat assembly back in vehicle.
15. When repairs are complete, adjust rear brakes before adjusting parking brake. See Parking Brake System Adjustments for complete parking brake adjustment procedure. On drum-in-hat type of rear disc brake adjust shoe diameter to 171.5 mm (6.75 inch).