Brake Drum: Service and Repair

Rear Brake Drum:

REMOVE
1. Raise vehicle on jackstands or centered on a frame contact hoist.
2. Remove the wheel and tire from the vehicle.

NOTE: Further clearance to allow easier removal of the brake drum can be obtained by backing off the brake automatic adluster screw.

3. Remove rubber plug from top of brake support plate.
4. Rotate automatic adjuster screw assembly with an upward motion, using a medium size screwdriver. Refer to Drum Brake System Adjustments for the proper procedure.
5. Remove rear brake drum from rear hub and bearing.
6. Inspect brake linings for wear, shoe alignment and contamination.

INSTALL
1. Install rear brake drum assembly on rear hub and bearing assembly.
2. Install the wheel and tire assembly.
3. Tighten the wheel mounting stud nuts in proper sequence until all nuts are torqued to half specification. Then repeat the tightening sequence to the full specified torque of 110 - 135 Nm (85 - 115 ft. lbs.).
4. Adjust rear brake shoes. Refer to Drum Brake System Adjustments for the proper procedure.
5. Lower vehicle.