Power Antenna

REMOVAL
The rubber bezel grommets are not inter changeable between vehicle models. There are three types of grommets in use, check with parts catalog for proper grommet. If there is a water leak check for proper grommet.
1. Disconnect battery negative cable.
2. Inside trunk, pull trunk liner aside.

Power Antenna:

3. Unplug antenna lead from pigtail connector, disconnect wire connector, remove drain tube from grommet.
4. Remove screws attaching ground strap and antenna brace.
5. Pull antenna body down through the rubber grommet.

INSTALLATION
For installation reverse the above procedures. Check that the grommet locating tab is in-line with the slot in the body before installing antenna. Tighten antenna bracket ground strap screws to 4 N.m (40 in. lbs.) torque.