Driver Side Airbag Module Replacement

WARNING: Before attempting to diagnose, remove or install any airbag system components, unless otherwise noted, you must first disconnect and isolate battery ground cable. Failure to do so could result in accidental deployment and possible personal injury.

WARNING: If replacing a deployed module, wear gloves and eye protection. There will be deposits on and around the airbag that could cause skin and eye irritation. If material does come into contact with the body, flush with plenty of cold water.

Fig. 176 Driver Side Airbag Module Location:

REMOVAL
1. Ensure front wheels are in straight ahead position.
2. Disconnect and isolate battery ground cable. Wait minimum of 2 minutes before working on vehicle.
3. Remove speed control switches or covers from steering wheel and disconnect wiring.
4. Remove bolts securing airbag to steering wheel.
5. Lift module and disconnect wiring to airbag and horn.
6. Remove driver airbag from steering wheel.

INSTALLATION
1. Connect clockspring, horn and airbag wiring connectors to airbag module. Ensure connectors are fully seated by pressing straight in on the connector.
2. Install airbag module on steering wheel and torque bolts to 105-125 inch lbs.
3. Install covers on steering wheel or connect speed control switches and install switches on steering wheel.
4. Do not connect battery ground cable. Refer to Testing and Inspection/Procedures.