Fuel Filter: Service and Repair

Fuel Filter Location:

REMOVAL

1. Disconnect the negative battery terminal, and remove the fuel tank cap.
2. Raise, and support the vehicle for access.
3. Remove fuel filter hoses and clamps from the inlet and outlet fuel nipples. Remove the retaining strap bolt, and remove the filter.

INSTALLATION

1. Install the new filter in the retaining strap. Check the direction of flow by the markings on the filter, and ensure it is correct.
2. Install the retaining strap bolt, and torque to 8.8 ft-lbs (12 Nm)
3. Install the inlet and outlet hoses, and clamps. Tighten the clamps securely. Lower the vehicle. Connect the negative battery terminal.
5. Using the DRB II select the Automatic Shut Down (ASD) Fuel System Test to pressurize fuel system and check for leaks. SEE COMPUTERS AND CONTROL SYSTEMS/SCAN TOOL ORIENTATION.

CAUTION: Unless the test is stopped or the ignition switch is turned to the OFF position the fuel pump relay and the ASD relay will remain energized for 7 minutes by the ASD Fuel System Test.