Heated Glass Element: Service and Repair

REQUIRED MATERIALS:
^ Thinner ^ Lead-free gasoline
^ Tape ^ Fine brush
^ Conductive paint

Printed-Heater Line Repair:

1. Clean disconnected area with lead-free gasoline. Tape along both sides of heater element.

2. Mix conductive paint thoroughly. Thin the required amount of paint in a separate container with a small amount of thinner and paint break three times at 15 minute intervals.

3. Remove tape and leave for a while before use (circuit complete).

4. When completely dry (after 24 hours) finish exterior with a knife.
CAUTION:
Clean glass with a soft cloth (dry or damp) along defogger heater element.