Component Testing

Top Dead Center (TDC) Sensor Circuit:

OSCILLOSCOPE TESTING PROCEDURE:
1. Connect test leads from the oscilloscope to the #1 terminal of the sensor connector and run the engine at idle speed.

Scope Test Waveform--single Rotation Of The Distributor:

2. Check the waveform and compare it to the diagram shown.

VOLTAGE TESTING PROCEDURE:
1. Connect a voltmeter between terminal 3 and 1 of the crank angle sensor connector.
Terminal 1: Camshaft (TDC) signal
Terminal 4: Sensor ground
2. Measure the output voltage of the terminals while cranking the engine.
Standard approximate value
2.0 - 2.5v
3. When the voltage is abnormal, check the sensor power and ground circuits.


If any of the previous tests produce unsatisfactory results, the harness will need to be repaired or replaced. Once repairs have been completed, clear the trouble codes and road test the vehicle to confirm that the repair has corrected the problem and the code doesn't return.


If the same trouble code reoccurs, it is possible that there is an intermittent failure of the component or the ECM. Check for looseness at all harness junctions and test for an intermittent failure.