A/C - Inoperative/Operates Intermittently
NO.: 24-07-93GROUP: Air Conditioning
DATE: Mar. 5, 1993
SUBJECT:
Intermittent Or Inoperative A/C
MODELS:
1993 (LH) Concorde/Intrepid/Vision
DISCUSSION:
The A/C clutch connector and pressure transducer switch connector terminal contacts can be damaged by probing tools during system diagnosis and repair. Failure to use their respective mating terminals or pin gauge to check for tightness of the female terminal contact may cause contact beam spreads and loss of continuity.
The proper probe/pin gauge size for these connectors is:
A/C Clutch Connector 1.0 mm
A/C Pressure Transducer Switch Connector 0.6 mm
NEVER INSERT ANYTHING LARGER THAN THE MALE MATING TERMINAL INTO THE FEMALE TERMINAL. TERMINAL FAILURE MAY OCCUR.
If damage occurs proceed with the repair procedure.
PARTS REQUIRED:
AR A/C Pressure Transducer Sensor Connector 4728323
AR A/C Clutch Connector 4728321
REPAIR PROCEDURE:
This repair involves replacing the damaged connector(s).
1. With the engine off, disconnect the wiring connectors and inspect for damage.
2. If damage exists replace the wiring connector following package instructions.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor Operation No. 24-35-71-92 0.3 Hrs.
FAILURE CODE:
X6 - Terminals Damaged