Code Message to Code Number Conversion

NOTE: In most cases, codes do not pinpoint which specific component is defective.

NOTE: Diagnostic Trouble Code (DTC), messages for the Electronic Automatic Transaxle (EATX) are listed below, followed by the code numbers and whether or not the vehicle will to go into limp-in mode if a specific code is set.

Scan Tool Message Code Limp-In

Internal Controller (Watchdog Circuit Test) 11 Yes
Battery Was Disconnected 12 No
Internal Controller (Watchdog Circuit Test) 13 Yes
Relay Always On 14 Yes
Relay Always Off 15 Yes
Internal Controller (ROM Check Failure) 16 Yes
Internal Controller (RAM Check Failure) 17 Yes
Engine Speed Sensor 18 Yes
BUS Communication With PCM 19 No
Switched Battery 20 Yes
OD Pressure Switch Circuit 21 Yes
2-4 Pressure Switch Circuit 22 Yes
2-4/OD Pressure Switch Circuit 23 Yes
L-R Pressure Switch Circuit 24 Yes
L-R/OD Pressure Switch Circuit 25 Yes
L-R/2-4 Pressure Switch Circuit 26 Yes
All Pressure Switch Circuits 27 Yes
Bad TRS Data 28 No
Throttle Position Signal 29 No
OD Hydraulic Pressure Switch Circuit 31 Yes
2-4 Hydraulic Pressure Switch Circuit 32 Yes
OD/2-4 Hydraulic Pressure Switch Circuit 33 Yes
Loss of Prime 35 Yes
Fault Immediately After a Shift 36 Yes
Solenoid Switch Valve Latched in TCC Position 37 No
TCC Out of Range 38 No
L-R Solenoid Circuit Error 41 Yes
2-4 Solenoid Circuit Error 42 Yes
OD Solenoid Circuit Error 43 Yes
UD Solenoid Circuit Error 44 Yes
Internal Controller (EEPROM Byte Failure) 45 No
UD Hydraulic Circuit (3-4 Shift Abort) 46 No
Solenoid Switch Valve Latched In L-R Position 47 Yes
Output and Input Speed Checks:
- Speed Error in Reverse 50 Yes
- Speed Error in 1st 51 Yes
- Speed Error in 2nd 52 Yes
- Speed Error in 3rd 53 Yes
- Speed error in 4th 54 Yes
- Input Speed Sensor Error 56 Yes
- Output Speed Sensor Error 57 Yes
- Sensor Ground Error 58 Yes
Inadequate Element Volume:
- L-R 60 No
- 2-4 61 No
- OD 62 No

NOTE: Diagnostic trouble codes for the transmission system are not permanent, and will change the moment the problem causing the code to be set is corrected.