Test 4 - Top Dead Center Sensor Testing

To test the Top Dead Center (TDC) Sensor, proceed as follows.

Fuel Injection - W/Automatic Transaxle:

VOLTAGE TESTING PROCEDURE:

1. Connect a voltmeter between terminal 1 and 3 of the crank angle sensor connector.
Terminal 3: Top Dead Center (TDC) signal
Terminal 1: Sensor ground

2. Measure the output voltage of the terminals while cranking the engine.

Standard Approximate Value

Terminal 3: 2.0 - 2.5v


3. If signal is abnormal or not present, check connector pin # 2 for near battery voltage and pin # 1 for a good ground. Repair as necessary, and recheck. If signal is normal refer to TEST 5 .


OSCILLOSCOPE TESTING PROCEDURE:



1. Connect test leads from the oscilloscope to the #3 terminal of the sensor connector and run the engine at idle speed.

Scope Pattern:

Check the waveform and compare it to the diagram shown.