Floor Mount

SHIFTER - FLOOR MOUNT





1. If a new shifter assembly is being installed, use a trim stick (1) to separate the shift knob lower trim (3) from the shift knob (2).





2. Pull up on the shift knob (1) to remove the knob from the shaft then remove the lower trim (2).
3. Install the lower trim onto the new shifter shaft. Install the shift knob onto the shaft by hand. Install the lower trim onto the shift knob.










4. Install shifter assembly (1) onto the shifter assembly studs on the floor pan.
5. Install the nuts (2) to hold the shifter assembly (1) onto the floor pan. Tighten nuts to 7 Nm (65 in.lbs.).










6. Place the floor shifter lever in PARK position.
7. Loosen the adjustment screw (5) on the gearshift cable (1).
8. Install the gearshift cable (1) to the shift lever pin (3).




Figure 5 - Shifter Wiring Connectors





9. Install the wiring harness connectors (2) to the shifter assembly.
10. Verify that the shift lever is in the PARK position and the transmission park sprag is set by rocking the vehicle.
11. Tighten the adjustment screw to 7 Nm (65 in.lbs.).
12. Verify correct shifter, park lock, and BTSI operation.
13. Install any console parts removed for access to shift lever assembly and shift cables. Floor Console - Installation