Cylinder Head Assembly

CYLINDER HEAD ASSEMBLY






NOTE: Left side shown, right side similar.

Tighten the cylinder head bolts 1 through 10 34 Nm (25 ft. lbs.)
Tighten the cylinder head bolts 11 through 15 20 Nm (15 ft. lbs.)
Tighten the cylinder head bolts 1 through 10 54 Nm (40 ft. lbs.)
Tighten the cylinder head bolts 11 through 15 20 Nm (15 ft. lbs.)
Rotate the cylinder head bolts 1 through 10 an additional 90° turn
Tighten the cylinder head bolts 11 through 15 34 Nm (25 ft. lbs.)






WARPAGE

If tolerances exceed 0.0508 mm (0.002 in.) replace the cylinder head.






CAMSHAFT BEARING CAP

Tighten camshaft thrust plate retaining bolts 12 Nm (106 in. lbs.)

INTAKE MANIFOLD
Intake Manifold Specifications

EXHAUST MANIFOLD
Exhaust Manifold Specifications

CAMSHAFT GEAR/SPROCKET
Camshaft Gear/Sprocket Specifications