Windshield Washer Reservoir - Installation

INSTALLATION





1. Lift the washer reservoir (1) up into the vehicle and position it to the outboard side of the right frame rail (3).
2. Install and tighten the two screws (2) that secure the reservoir to the frame rail. Tighten the screws securely.





3. Reconnect the washer hose (2) to the barbed outlet nipple of the washer pump (7).
4. Reconnect the headlamp and dash wire harness (1) connector for the washer pump/motor unit (5) to the connector receptacle on the top of the pump motor.
5. Reconnect the headlamp and dash wire harness connector for the washer fluid level switch (6) to the connector receptacle for the switch (3).
6. Reinstall the Electro-Hydraulic Power Steering (EHPS) pump onto the outboard side of the right frame rail. Power Steering Pump - Installation.
7. Reconnect the battery negative cable.
8. Refill the washer reservoir with the washer fluid drained from the reservoir during the removal procedure.