Rear Door Glass - Removal

REMOVAL





1. Raise the rear door glass up to it's full position.
2. Remove the trim panel from the inside of the rear door, Rear Door Trim Panel - Removal.
3. Remove the inner belt weatherstrip from the rear door.
4. Remove the cover for the regulator tab access hole.
5. Temporarily install the window switch pod, reconnect the negative battery cable and lower the window until the white regulator tab is visible in the access hole (2).
6. With the help of an assistant holding the glass, release the window regulator tab and lift the window up and tape the glass (1) to the door header.
7. Remove the outside door handle.
8. Remove the door carrier plate, Rear Door Carrier Plate - Removal
9. Remove the tape securing the glass, lower and remove the glass through the carrier plate cavity.