Rear Shock Absorber - Installation

NON SRT





1. Insert lower end of shock absorber (3) into well of spring link (4).





2. Raise upper end of shock absorber (4) up into mounted position on body (1) and install upper mounting screws (2). Tighten upper mounting screws to 52 Nm (38 ft. lbs.).





3. Install lower shock mounting bolt (2) and nut (4). Do not tighten at this time.
4. Remove under-hoist utility jack or jack stand from under spring link.





5. Install tire and wheel assembly (1). Tighten wheel mounting nuts (3) to 150 Nm (110 ft. lbs.) . Tires And Wheels - Installation
6. Lower vehicle.
7. Position vehicle on alignment rack/drive-on hoist. Raise vehicle as necessary to access lower mounting bolt.





8. Tighten shock absorber lower mounting bolt nut (4) to 72 Nm (53 ft. lbs.).