Seat Belt Turning Loop Adjuster - Removal

REMOVAL

WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts, buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the Chrysler Mopar(R) Parts Catalog.





1. Remove the trim from the inside of the B-pillar (1). B-Pillar Trim Panel - Removal.
2. Remove the nut (5) that secures the seat belt turning loop (4) to the stud on the height adjuster (3).
3. Remove the seat belt turning loop from the height adjuster.
4. Remove the two screws (2) that secure the height adjuster to the upper inner B-pillar.
5. Remove the seat belt turning loop adjuster from the B-pillar.