Rear

REAR SEAT

WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts, buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the Chrysler Mopar(R) Parts Catalog.






NOTE: The right outboard and center rear seating position buckles (5) are serviced only as a unit. The left outboard rear seating position buckle (3) is integral to the center rear seating position seat belt and retractor (2) lower anchor. Seat Belt Retractor - Removal .

1. Remove the rear seat cushion from the vehicle. Seat Cushion Cover - Removal.
2. Remove the nut (1) that secures the anchor plate of the right outboard and center rear seating position buckles (5) to the stud (4) on the center floor panel.
3. Remove the buckle unit from the vehicle.