Ignition Coil - Installation

3.6L





1. Using compressed air, blow out any dirt or contaminants from around the top of spark plug.
2. Check the condition of the ignition coil rubber boot (1). To aid in ignition coil installation, apply a silicone based grease such as Mopar(R) Dielectric Grease into the spark plug end of the rubber boot (2).






NOTE: The left side ignition coils are shown, the right side ignition coils are similar.

3. Position the ignition coil (2) into the cylinder head cover opening. Using a twisting action, push the ignition coil onto the spark plug.
4. Install the ignition coil mounting bolt (3) and tighten to 8 Nm (71 in. lbs).
5. Connect and lock the electrical connector (1) to the ignition coil (2).





6. If removed, install the insulator, upper intake manifold (1) and air inlet hose Intake Manifold - Installation.





7. Connect the negative battery cable and tighten nut to 5 Nm (45 in. lbs.).





8. Position the engine cover (1) and secure the retaining grommets onto the ball studs.