Spot Lamp Bulb - Removal

BULB

NOTE: Spot lamps are offered with either a standard halogen lighting unit or an optional Light Emitting Diode (LED) lighting unit. The service procedures for both lighting elements are the same, only the lighting element type is different.





1. Disconnect and isolate the battery negative cable.
2. Raise the spot lamp head from the stowed position to the operating position.
3. While supporting the spot lamp head housing, remove the screw (4) at the base that secures the bezel (1) to the spot lamp head housing (3).
4. Unlock the bezel from the housing by rotating the bezel counterclockwise.
5. Remove the bezel from the spot lamp head housing.
6. Tilt the spot lamp sealed beam (2) out of the head housing far enough to access and disconnect the spot lamp wire harness connectors (5) from the terminals on the back of the reflector.
7. Remove the sealed beam from the spot lamp.