Speed Control Switch - Installation

INSTALLATION

WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.





1. Position the speed control switch pod (2) and the mounting adapter plate (3) to the back of the right steering wheel spoke front bezel (1).
2. Install and tighten the three screws (4) that secure the mounting adapter plate and the switch to the bezel. Tighten the screws securely.
3. Position the right front spoke bezel close enough to the steering wheel to reconnect the steering wheel wire harness connection to the connector receptacle integral to the inboard end of the speed control switch pod.
4. Engage the lip on the inboard side of the bezel under the edge of the driver airbag trim cover.
5. Position the right front spoke bezel, mounting adapter plate and speed control switch pod as a unit to the steering wheel. Be certain that the steering wheel wire harness is not pinched.





6. From the back of the right horizontal spoke of the steering wheel (1), install and tighten the screw (3) that secures the mounting adapter plate, right spoke front bezel and speed control switch to the steering wheel spoke. This screw is located between the remote radio switch (4) and the floating horn switch mounting screw clearance hole (2). Tighten the screw securely.
7. Reconnect the battery negative cable.