Sensor

SENSOR






NOTE: The molded plastic ball socket clips in the ACC sensor mounting bracket MUST be removed, discarded and replaced with new ball socket clips any time the sensor is removed from the bracket.

1. Install three new molded plastic ball socket clips into the adaptive speed control (also known as Adaptive Cruise Control/ACC) sensor mounting bracket (2) located below the right side of the front bumper support bar (1). The clips are installed from the back side of the bracket by rotating them clockwise.
2. Position the ACC sensor (4) to the mounting bracket.
3. Align the one fixed and the two adjustable ball studs of the sensor with the three plastic ball socket clips in the bracket.
4. Using hand pressure, press firmly and evenly on the face of the sensor until each of the ball studs snaps into the ball socket clips.
5. Reconnect the Front End Module (FEM) wire harness connector (5) to the ACC sensor connector receptacle.
6. If equipped, snap the sensor bezel (mirror cover) (3) over the face of the ACC sensor.
7. Check the ACC sensor vertical alignment. Adjustments.





8. Snap the bezel (2) into the right lower air intake opening of the front fascia (1).
9. Use a diagnostic scan tool and the appropriate diagnostic information to perform the horizontal sensor alignment procedure.