Brake Tube Junction Block - Installation

INSTALLATION





1. Install junction block (5), pushing mounting bracket down into mounting grommets (8) located in body of vehicle.





2. Install brake tubes to rear (1 and 3) at hydraulic control unit. Tighten tube nuts to 20 Nm (177 in. lbs.) torque.





3. Install brake tubes (1, 2, 3 and 10) at junction block (5). Tighten tube nuts to 20 Nm (177 in. lbs.) torque.
4. Remove brake pedal holding tool.





5. Connect battery negative cable (2) to battery post. It is important that this is performed properly.





6. Fill and bleed (1) base brake hydraulic system. Service and Repair
7. Road test vehicle to verify proper operation of brakes.