Rear

INSTALLATION





1. Insert wheel speed sensor head (3) into mounting hole in rear of knuckle.
2. Install screw (2) fastening sensor head (3) to rear knuckle. Tighten Screw to 11 Nm (97 in. lbs.).
3. Install sensor cable at rear brake rotor shield (1).





4. Clip sensor cable (2) to routing clips (3) along toe link.
5. If installing left sensor, clip sensor cable (2) to routing clip (1) above toe link mount on rear crossmember.





6. If installing left sensor, clip sensor cable (1) to routing clips (2) along rear of crossmember near rear differential (3).





7. If installing left sensor, clip sensor cable (3) to routing clip near body connector (1).





8. Match left sensor connector (4) to right sensor connector (3) to make one connector.
9. Insert sensor connectors (3 and 4) into body wiring harness connector (1) located in luggage compartment floor pan (2). When installing connector, make sure retaining clip on body connector is properly in place and sensor connector cannot be pulled out.
10. Lower vehicle.
11. Perform Verification Test and clear any faults Verification Tests.