Sunroof - Removal

REMOVAL






WARNING: The excessive force limitation (EFI) feature must be calibrated any time a sunroof motor/module is replaced with a new component. Failure to perform this procedure could result in vehicle damage and/or personal injury. Programming and Relearning for the appropriate procedure.

1. Move glass panel to the fully closed position.
2. Disconnect and isolate the battery negative cable.
3. Lower the headliner Headliner - Removal.
4. Disconnect the sunroof wire harness electrical connector.





5. Disconnect the four drain tubes (1) from sunroof housing.





6. Remove the eight fasteners (3) attaching sunroof assembly.
7. With the aid of a helper, support the sunroof and remove the fasteners (2) attaching sunroof assembly (1) to roof panel.
8. Remove the sunroof (1) from vehicle.