Instrument Cluster Switch Pod - Installation

INSTALLATION

WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.

SWITCH-BANK AND BEZEL ASSEMBLY





1. Position the switch-bank assembly in place.
2. Connect the electrical connector (2) to the back of the switch-bank assembly (1).





3. Position the switch-bank in the IP and press firmly to engage the clips (3), securing the switch-bank to the IP.
4. Install the center console cubby bin (2), Floor Console - Installation.

CAUTION: Use care when removing or installing the cubby bin, not to damage or distort the guide pins (4) on either side.

5. Connect the negative battery cable.