Rear Suspension Stabilizer Bar - Installation

INSTALLATION





1. If required, install the two cushions on the stabilizer bar (one on each side) utilizing the slit cut into the cushions (bushings).
2. Position the stabilizer bar (2) on the rear crossmember.
3. Install the two retainers (1) over the cushions at the mounting holes and install the retainer screws (3). Do not tighten the screws at this time.





4. On each side of the vehicle, install the stabilizer link upper stud in the end of the stabilizer bar (3). Install the nut (1) on each upper stud and while holding the stabilizer link stud stationary, tighten the nut (2) to 50 Nm (37 ft. lbs.).





5. Tighten the cushion retainer screws to 34 Nm (25 ft. lbs.).
6. Lower the vehicle.