Ignition Lock Cylinder - Installation

INSTALLATION





1. Place actuator in the lock cylinder housing to the RUN position (if not already there).
2. Insert key into key cylinder and turn key cylinder to the RUN position.
3. Align the retaining tab on the key cylinder with the slot in the top of the lock cylinder housing.
4. Slide key cylinder into the lock cylinder housing until key cylinder retaining tab locks the cylinder into place.
5. Rotate key back and forth (OFF to START), then remove and reinstall it, making sure key cylinder and lock cylinder housing operate properly.





6. Slide the ring of SKREEM/WCM (2) over lock cylinder housing (3) and engage the retainer fingers in the recesses formed on the lock cylinder housing.
7. Install screw (1) fastening the SKREEM/WCM (2) to lock cylinder housing (3). Tighten screw to 2.5 Nm (22 in. lbs.).





8. Install and tighten the screw (2) that secures the mounting tab on the back of the right multi-function switch (1) to the mounting bracket on the clockspring (3).





9. Install steering column opening cover, Steering Column Opening Cover - Installation.





10. Install upper (1) and lower (2) steering column shrouds,Steering Column Shroud - Installation.





11. Install air cleaner fresh air duct (2) and disconnect and isolate negative battery cable at battery, Battery - Installation.
12. Check operation of all steering column mounted components.