Speed Control Switch - Removal

REMOVAL

WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.





1. Disconnect and isolate the battery negative cable.
2. Remove the horn switch from the steering wheel. Horn Switch - Removal
3. Disconnect the steering wheel wire harness connector (1) from the speed control switch connector receptacle.
4. Remove the three screws (2 and 4) that secure the speed control switch (3) to the steering wheel armature.
5. Remove the speed control switch from the steering wheel.