Seat Belt Switch - Installation

INSTALLATION

WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.

WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts, buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the Chrysler Mopar(R) Parts Catalog.

NOTE: The following procedure is for replacement of an ineffective or damaged seat belt switch unit. The front retractor also includes a seat belt tensioner. If the front seat belt switch is ineffective or damaged, but the seat belt tensioner is not deployed, review the recommended procedures for Handling Non-Deployed Supplemental Restraints. Service and Repair . If the seat belt tensioner has been deployed, review the recommended procedures for Service After A Supplemental Restraint Deployment before removing the unit from the vehicle. Service and Repair .





1. Extract the seat belt webbing (1) from the retractor far enough to allow clearance between the seat belt switch plunger (5) and the webbing on the retractor spool during switch installation.
2. Position the seat belt switch (4) to the lower edge of the retractor frame tie bar (3) with the plunger oriented toward the retractor spool.
3. Push the switch onto the tie bar until the integral latch feature (2) is fully engaged over the tie bar.
4. Reinstall the front seat belt retractor onto the lower B-pillar. Seat Belt Retractor - Installation.