Fog Lamp - Installation

LAMP





1. From the face of the front fascia, position the front fog lamp and bracket unit into the fascia seat (1).
2. Engage the two alignment pins on the back of the fog lamp bracket with the alignment holes in the seat, then push the lamp rearward far enough to engage the three latch features (2) of the fog lamp bracket with the opening on the back of the seat.
3. Reach up behind the front fascia to install and tighten the two screws (4) that secure the lamp to the back of the fascia. Tighten the screws to 2 Nm (14 in. lbs.).
4. Reconnect the engine compartment wire harness connector to the front fog lamp bulb connector receptacle (3).





5. Position the front of the front wheel house splash shield (4) to the front fascia (2) closure panel and secure it with two push pin fasteners (3).
6. Install the push pin fastener (3) that secures the inboard side of the splash shield to the front end sheet metal.
7. Install and tighten the three screws (1) that secure the outboard side of the splash shield to the front fascia. Tighten the screws to 2 Nm (19 in. lbs.).
8. Reinstall the front wheel and tire. Tires And Wheels - Installation.
9. Lower the vehicle.
10. Reconnect the battery negative cable.
11. Confirm proper front fog lamp alignment. Adjustments.