Fog Lamp Bulb - Removal

BULB

CAUTION: Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb life will result.





1. Disconnect and isolate the battery negative cable.
2. Raise and support the vehicle.
3. Remove the front wheel and tire on the same side of the vehicle as the fog lamp being serviced. Tires And Wheels - Removal.
4. Remove the three screws (1) that secure the outboard side of the front wheel house splash shield (4) to the front fascia (2).
5. Remove the push pin fastener (3) that secures the inboard side of the splash shield to the front end sheet metal.
6. Remove the two push pin fasteners that secure the forward edge of the splash shield to the front fascia closure panel.
7. Fold the front of the splash shield rearward far enough to access the back of the front fascia.





8. From behind the front fascia disconnect the engine compartment wire harness connector from the front fog lamp bulb connector receptacle (1).
9. Firmly grasp the bulb by the two latch features (2) and squeeze them together to unlock the bulb from the back of the front fog lamp housing (3).
10. Pull the bulb straight out from the keyed opening in the housing.