Air Distribution Housing

HOUSING-AIR DISTRIBUTION

NOTE: LHD model with A/C shown in illustrations. RHD and heater-only models similar.





1. Position the air distribution housing (2) onto the rear of the HVAC housing (4) and engage the one plastic retaining clip.
2. Install the six screws (1) that secure the air distribution housing to the HVAC housing. Tighten the screws to 1.2 Nm (10 in. lbs.).
3. Install the two metal retaining clips (3) that secure the bottom of the air distribution housing to the HVAC housing.
4. Install the heater core Heater Core - Installation.
5. Install the floor distribution ducts Floor Distribution Duct - Installation.

NOTE: If the heater core is being replaced, flush the cooling system Service and Repair .

6. Install the HVAC housing assembly HVAC Housing - Installation.