A/C And Heater Control - Installation

INSTALLATION

NOTE: Take the proper precautions to protect the front face of the center bezel from cosmetic damage while performing this procedure.






NOTE: MTC A/C-heater control shown. ATC A/C-heater control similar.

1. Position the A/C-heater control (2) onto the back of the center bezel (3).
2. Install the four screws (1 and 4) that secure the A/C-heater control to the bezel. Tighten the screws to 2 Nm (17 in. lbs.).
3. Install the center bezel Instrument Panel Center Bezel - Installation.
4. Reconnect the negative battery cable.

NOTE: When installing a new A/C-heater control, or reinstalling the original control, the A/C-heater control will automatically run the Actuator Calibration function when the ignition switch is initially turned to ON. However, the Actuator Calibration function must be manually initiated using a scan tool if the A/C-heater control was previously installed in another vehicle.

5. If required, initiate the Actuator Calibration function using a scan tool .